D019 handheld clothing sensor remover tool magnet is withspecial handheld design. This design makes it very convenient to carry it to remover security tags on big items by the the staff. The tail can also be used with a wire rope and fixed at the checkout counter.
D019clothing sensor remover tool is made of high quality magnet.This anti theft clothing tag remover is able to remove pins from almost all magnetic hard tags.
This clothes sensor removing device is compatible with all standard or super lock retail security tags. Such as Ink tag, Wine tag, Checkpoint tag, Spider tag, Hammer tag, UFO tag, Milk can tag, Square tag, H&M tag, Uniqlo sensor tag. The handheld sensor remover is a very powerful clothing tag removal tool which answers the question how to remove security tag from clothing.
This is the most powerful magnetic tag detacher in its class. It has a super magnetic aluminium coating which gives it its silvery color.
D019 is a handheld clothing sensor remover tool magnet is suitable for use in supermarkets, fashion stores, or any store where there is a need to save time by using a strong universal tag detacher magnet
FAQs
Neodymium magnets are needed, The tricky part is how to position them for the field to cancel out. Your magnet has to be electrical, and it must create a large current in the tag, enough to burn up an electrical trace.
How do you remove a security tag with your hands? ›
Freeze the garment overnight for best results. Rip open the tag. You can just use your hands, pliers, or the rubber band method. This will ensure that the ink won't spill everywhere if you make a mistake -- ink can't spill if it's frozen.
Can a normal magnet remove a security tag? ›
These mysterious devices are rather simple devices. While they can be mutilated off with a pair of snips, a screwdriver and a pair of pliers, they can be removed much easier with a high powered magnet. I used a hard drive magnet and a light touch.
What tool is used to remove security tags? ›
Anti-theft tags can easily be removed at home, which may or may not require a simple tool such as a pair of pliers, screwdriver, or even a butter knife.
Which security tags have ink in them? ›
Ink tags are a form of retail loss prevention that is commonly used in clothing stores. These tags contain glass vials filled with permanent ink and have a thick plastic cover. The tags are attached to the items they protect with a magnetic lock which requires a special tool to remove.
What tool do stores use to remove security tags? ›
To remove the security tag, employees will use a deactivator at the POS integrated with barcode scanners.
What is the easiest way to remove a security tag? ›
How do you remove safety tags from clothing? If it's the type with a dome on one side, get a neodymium magnet, hold it up to the dome, push the pin inward from the other side, then pull the parts apart.
Do magnets disable RFID tags? ›
At first glance, a strong magnet may seem like it would be capable of killing an RFID chip. However, a closer look reveals that the metal layer on the chip is actually very thin and wouldn't be affected by a strong magnet. In fact, a magnet could even stick to the back of the chip and prevent it from working properly.
Does cutting an RFID tag disable it? ›
-The third method is cutting the antenna very close to the chip. By doing this the chip will have no way of receiving electricity, or transmitting its signal back to the reader. This technique also leaves minimal signs of damage, so it would probably not be a good idea to use this on a passport.
Does aluminum foil block security sensors? ›
It is fairly common for shoplifters to use aluminum foil to try to defeat alarms. The aluminum foil is used as a barrier to prevent sensors from detecting security devices attached to merchandise. When shoplifters avoid alarms, they can escape with the stolen goods.
To set about removing security tags, place your security tag remover magnet on a table or other flat surface. Then, touch the base of the tag to the magnet. You should hear a clicking noise, at which point you can begin wiggling the other side of the tag until the pin comes loose.
