- 0
How a Running Shoe is Made
How Running Shoes are Made
All running shoes are made by the cold cement construction process. If you want to learnhow to design shoes you need to know this basic shoe making process. Cold cement is the modern updated style of shoe construction. Due to the low temperatures required for bonding the upper to the shoe sole, itallows the use of modern lightweight plastic, foam and mesh materials. Every modern high performance running shoe is made by this cold cement process.
Running Shoe Upper StitchingProcess:
What are the best materials for running shoes? Most running shoes are constructed with breathable knit Polyester or Nylon mesh. Knit fabric allow the material to smoothly follow the last curves. Running shoe uppers often with PU leather reinforcements. Pu or synthetic leathers are great for running shoes as they have some stretch and are damaged by water. The classic running shoe is made from suede with some mesh inserts. While suede is comfortable and conforming, it’s not weather resistant and it’s very heavy when wet.
Thepattern parts for the shoe are made into steel cutting dies. A cutting die is required for every part and every size. Each shoe part is cut from rolls of fabric or from leather hides. Fabric parts may be layered so many can be cut at the sametime. Leather parts must be cut one by one to avoid having scars or other imperfections in the leather show on the final product.
The factoriescutting department cuts all the parts for each running shoe, then gathers the parts into kits. One kit for each pair of shoes. After several hundred or even 1000 kits are complete they are passed to the stitching department for assembly.
The stitching department builds the parts of the running shoe sewing then together,finally closing the shoe and adding the tongue.
RunningShoe Production Assembly Process:
The running shoe upper is prepared with the strobel bottom. The outsole covers the edge of the upper so a strobel bottom can be used to make the shoe lighter and more flexible.
The running shoe upper is steamed to soften the materials and the last is inserted and pulled tight. Once the lastis tight inside the uppera second lasting machine pulls the heel edge. Once the last is secured inside the upper, temporary shoes laces are pulled tight, and the upper is cooled which allows the upper toshrink and fittight to the last.
The shoe may have a plastic or fabric part installed on top of the tongue to protect the surface from damage and drift during the lasting operations.
While the upper is being lasted, the sole unit is being prepared. In this case, a rubber sheetsole is combinedwith the EVA foam cushioning component cemented inside. This is done in a separate process that’s called stock fitting.
Running shoemidsoleswill be made fromweightEVA foam. A thin layer of rubber will allow the EVA to flex, but protect the midsole from wear.
Now that the upper is lasted tightly and the outside unit is compete, the two pieces come together. The rubber sole unit will receive coatings of primer and cement. The outsole will get its own special primer designed for EVA and rubber. The shoe upper is also prepared with its own special primer and cement.
After the contact cement and primer have been completely dried in the heating tunnels, the two pieces are joined together by hand. Askilled worker aligns the upper and outsole together then places the shoe in a hydraulic press.
The running shoe will have 3 pressing operations, usually all done with one machine: a vertical press, toe and heel press, and side pressing. This insures full contact between the upper and outsole uit. Once the shoe is pressed together it’s often put in the cooling tunnel to set the glue.
After the cooling tunnel, a shoe de-lasting machine is used to push the last out of the shoe without wrinkling the running shoe upper.
Now the running shoe is complete! At this point you can insert the footbed. The footbed may be molded EVA with a fabric cover or flat sheet cut foam. The flat die-cut footbed is usually cemented inside the shoe, while molded footbeds are most often removable.
The new runner is ready for a final QC inspection – a quick check for any loose threads, cleaning and then packing.
PrevPreviousWhat Shoe Factory Equipment do I need to make custom Sneakers?
NextThe History of Sneakers PosterNext
